Even better value due to the higher than average service-life
Due to new motoring technology andadditional control, additional control, it has been possible toincrease the standard service-life of collectormotors considerably increase the standard service-life of collector motors considerably.
In a simulated laboratory environment and using different extraction cycles, a lifeexpectancy increase of up to 200% higher than the previous model was observed! In one extreme case, the tests even showed an operating life of up to 2,400 working hours.
Even the finest of motors end their servicelife at sometime. Then it basically means: The unit must be either sent in for maintenance or the service technician will come to you. In both cases there are down-times to endure and often high costs involved.
Not the case with the Silent TS. As withthe previous model, it is possible for the operator to change the motor personally. And that, in only 2 minutes and completely without tools .
Adaptable to each consumer
Due to its high suction performance of 3,300 l/min (volume flow rate), it is possible to connect the new Silent TS to two working places or units at the same time and provide effective protection of laboratory air. In addition to this, the filterchange-recognition and the automatic switch-on function can be easily and accurately adapted to suit each individual situation. These special performance features, enable the Silent TS to fit in perfectlywith laboratory and practice processing chains.
Unlike most other extraction units, it is not necessary to send the new Silent TS in for servicing, therefore expensive repair costs and annoying downtimes are a thing of the past. Those who really want to play it safe can order a replacement motor immediately and then not even have to wait for delivery. Most certainly an attractive option, due to the unbeatably low cost of a replacement motor – less than 10%of the purchasing price of the Silent TS!
The filter-change-recognition can be individually calibrated in order to reach the maximum fill level of the dust bag, and adapted to the different suction tubediameters. This means the suction unit will give notification when it is actually necessary to change the filter and not when the pre-set factory setting suggests.
That means: Better use of the fill volume, less dust bag wastage and therefore lower working expenses.
